X SYSTEM +
Self bonding silicone tape - COLOURLESS
Permanent Air-Tight Moisture - Proof seal. Founctions from -50C° to +260°C.
Insulates to 8000 Volts (per unstretched layer)
X SYSTEM + is a self-bonding silicone insulating & repair tape. It resists to extremes temperature, pressure, voltage, salt-water, U.V Rays, Acids, moisture and corrosion.
• Is Self-Fusing...No Adhesive
• Withstands Over 500°F (260°C) of Heat
• Remains Flexible to -50°C
• Has an Amazing 700 PSI Tensile Strength
• Insulates to 8,000 Volts per Unstretched Layer
• Stretches 300%
Clean the surface that will be wrapped and cut off the length of tape to be used. Remove and discard the clear separation film. X SYSTEM + works on either side. Hold one end of the X SYSTEM + in position against the object to be wrapped and apply a complete wrap around the object and back onto itself. This initial wrap secures the tape for additional wraps. Maintain a constant stretch as you continue to wrap, making sure each new layer “half laps” onto the previous layer. These overlaps will fuse together. For pressure applications (such as radiator, garden and air hoses), stretch X SYSTEM + to the maximum and apply minimum two layers.
X SYSTEM + begins to fuse immediately, with a permanent, cohesive bond within 24 hours. Re-positioning is not recommended after 1-2 minutes of wrapping.
Self bonding silicone tape - COLOURLESS
Permanent Air-Tight Moisture - Proof seal. Founctions from -50C° to +260°C.
Insulates to 8000 Volts (per unstretched layer)
X SYSTEM + is a self-bonding silicone insulating & repair tape. It resists to extremes temperature, pressure, voltage, salt-water, U.V Rays, Acids, moisture and corrosion.
• Is Self-Fusing...No Adhesive
• Withstands Over 500°F (260°C) of Heat
• Remains Flexible to -50°C
• Has an Amazing 700 PSI Tensile Strength
• Insulates to 8,000 Volts per Unstretched Layer
• Stretches 300%
Clean the surface that will be wrapped and cut off the length of tape to be used. Remove and discard the clear separation film. X SYSTEM + works on either side. Hold one end of the X SYSTEM + in position against the object to be wrapped and apply a complete wrap around the object and back onto itself. This initial wrap secures the tape for additional wraps. Maintain a constant stretch as you continue to wrap, making sure each new layer “half laps” onto the previous layer. These overlaps will fuse together. For pressure applications (such as radiator, garden and air hoses), stretch X SYSTEM + to the maximum and apply minimum two layers.
X SYSTEM + begins to fuse immediately, with a permanent, cohesive bond within 24 hours. Re-positioning is not recommended after 1-2 minutes of wrapping.
X SYSTEM + - FICHE TECHNIQUE
Recevoir la fiche de sécurité
